$ Absolute component height: 2.26 JL BL relative to lower plane: 0Ĩ Properties/End point/Offset to end point of opening Enter an opening width of 1.105.ĩ Allplan does not take the inner or outer reveal into account on circular openings!Įnable the Suppress this message until the end of the program option to hide this message in future. In the Smart symbol 1 to n area, click and set the Sill to Outside.Ĭlick Height and enter the following values: In the view showing the corner in detail, you should notice how the reference point has moved.Ī perpendicular has been dropped from the corner to the line representing the outside of the wall. ![]() ![]() If required, use to select another anchor point.ģ Click the inside corner of the curved wall. Pay attention to the direction in which you enter the opening: the closed side of the preview has to point towards the outside.Make sure that you do not snap a point (see Tip)!. ![]() If it isn't, activate it now.ġ Use Qi Zoom Section to get a close-up view of the bottom left of the curved wall.Ģ Click the line representing the outside of the curved wall.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |